Files that contain Arcs are not rendered properly by pgcode. It looks like the renderer attempts to draw a straight line from the start of the arc to the end of the arc, instead of following the path of the curve/arc. This leaves a mess that doesn't particularly resemble the printed part:
It's not urgent, but if it's not a lot of effort to properly support, it would be helpful to be able to view printed files with arcs in them as they print. (could make arc resolution settings a configuration option somewhere if needed).
I know that ideally we should not use something like ArcWelder for Klipper prints outside of Octoprint, but I have a few already sliced gcode files run through ArcWelder. that I'd like to use without recreating
Files that contain Arcs are not rendered properly by pgcode. It looks like the renderer attempts to draw a straight line from the start of the arc to the end of the arc, instead of following the path of the curve/arc. This leaves a mess that doesn't particularly resemble the printed part:
It's not urgent, but if it's not a lot of effort to properly support, it would be helpful to be able to view printed files with arcs in them as they print. (could make arc resolution settings a configuration option somewhere if needed).
I know that ideally we should not use something like ArcWelder for Klipper prints outside of Octoprint, but I have a few already sliced gcode files run through ArcWelder. that I'd like to use without recreating