[SV08 toolchanger] bltouch header is wrong JST

[bitingsock]

the guide says the bltouch header is JST ZH1.5mm pitch, but if you measure it, it is actually JST SH1.0mm
I bought ZH1.5mm and they certainly do not fit

[bitingsock]

also in the "final configuration" picture it correctly labels the TAP header as PH2.0mm but the instruction just below incorrectly says XH which is 2.5mm

maybe this explains the confusion here:
https://www.mattmillman.com/info/crimpconnectors/common-jst-connector-types/#paxa

[bitingsock]

ok so, SH1.0 is also wrong as I just bought some and they are too small...
measuring again I'm seeing 1.25. I think that is "MX" aka "molex picoblade"
I will order and report

[bitingsock]

confirmed, they fit: the bltouch header is 1.25mm pitch
I also found random reddit and facebook posts claiming the same, albeit for different printers
products are labeled MX1.25, PB1.25, or Molex picoblade